HP StorageWorks 8000 NAS - Manual (Page 46)

44 Configuring Your System and Network
Using the Configuration Wizard
The Configuration Wizard automatically appears the first time you connect to
the NAS server using a web browser. After that, you can access the wizard to
perform guided configuration tasks as follows:
■ Open the Command View NAS web interface by typing the IP address in
the address or location field of a web browser (you configured this
address during installation). The Wizard (shown below) guides you
through configuration.
or
■ Access the Wizard through the Configuration tab of the Command View
NAS web interface by clicking Configuration Wizard > Actions > Launch
Wizard.
Note Do not use your browser's Forward, Back, or Refresh buttons
while the Configuration Wizard is running. Instead use the
Back and Next buttons in the Wizard.
Figure 1 Configuration Wizard