HP StorageWorks 2.32 Edge Switch - Manual (Page 185)

Edge Switch Element Manager user guide 185
Firmware download timed out. The director or switch did not respond
in the time allowed. The status of the
firmware install operation is
unknown. Retry the operation. If the problem persists,
contact the next level of support.
Firmware file I/O error. A firmware download operation
aborted because a file I/O error
occurred. Retry the operation. If the problem persists,
contact the next level of support.
Firmware file not found. The firmware version is not installed
(or was deleted) from the firmware
library at the HAFM appliance. Add the firmware version to the library
and retry the operation.
Incompatible configuration
between management style and
management server. If the Firmware is below the required
level, only FICON management style
is allowed if the FICON Management
Server feature is enabled. You
attempted to enable Open Systems
management style. Disable FICON Management Server,
enable the Open Systems Management
Server, or enable the Open Systems
management style.
Incorrect product type. When configuring a new product
through the New Product dialog box,
an incorrect product was specified. Select the correct product type for the
product with the network address.
Installing this feature key, while
online, will cause an IPL operation
on the switch and a momentary
loss of LAN connection. This
operation is non-disruptive to the
Fibre Channel traffic. Do you wish
to continue installing this feature
key? If the switch is online, installing the
new feature key will cause an internal
program load (IPL). The LAN
connection to the HAFM appliance
will be lost momentarily, but Fibre
Channel traffic will not be affected. Click Yes to install the feature key or No to
not install.
Internal file transfer error received
from director. The director or switch detected an
internal file transfer error. Retry the operation. If the problem persists,
contact the next level of support.
Invalid character in field. An invalid character was entered in
the Data field. Remove invalid characters from the entry.
Invalid configuration name. Attempted to save an address
configuration name with an invalid
name. Use up to 24 alphanumeric characters,
including spaces, hyphens, and
underscores.
Invalid feature key. The feature key was not recognized. Re-enter the feature key. Ensure that you
type each character in the correct case
(upper or lower), include the dashes, and
do not add any spaces at the end.
Table 8 Element Manager messages (continued)
Message Description Action