HP StorageWorks 2.32 Edge Switch - Manual (Page 82)

Configuring the switch 82
To set fabric parameters:
NOTE: The switch must be offline to change parameters in this dialog box. If it is not and you
activate values in this dialog box, a dialog box appears, prompting you to set the unit offline.
CAUTION: Setting the switch offline terminates all Fibre Channel connections.
1. Set the unit offline:
a. Select Maintenance > Set Online State. The Set Online State dialog box appears.
b. Click Set Offline. A warning box appears asking you to confirm the offline state.
c. Click OK.
2. Select Configure > Operating Parameters > Fabric Parameters. The Configure
Fabric Parameters dialog box appears.
Figure 26 Configure Fabric Parameters dialog box (Edge Switch 2/32)
NOTE: Ordinarily, you do not need to change values in this dialog box from their defaults.
Change the values if the switch will participate in a multiswitch fabric.
3. Use information under ” Fabric Parameters ” on page 83 to change settings as required for
parameters in this dialog box.
4. After you change settings, click the Activate button.