HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem User Manual
Page 38
Command line 38
Item Description
Port (optional)
The port to be used on the destination to send the log messages. Valid values
include 1 to 65536. The default value is 514.
Security (optional)
Secure transmission of the log messages. Valid values include "None" and
"STunnel". The default value is "None", and no encryption is used during
transmission.
The "STunnel" option can be used only if the transport protocol used is TCP.
Format (optional)
The timestamp format for the log messages. Valid values include "RFC3164"
(Nov 26 13:15:55) and "ISO8601" (1997-07-16T19:20:30+01:00). The
default value is "RFC3164".
State (optional)
Enables or disables the remote log destination. Valid values include "Enabled"
and "Disabled". The default value is "Disabled".
Example
->add log-target Destination=192.168.2.1 Port=600
Format=ISO8601 State=Enabled
Adds log-target 192.168.2.1
Item Description
remove log-target
Remove an existing remote logging destination.
Syntax
remove log-target <ID>
Property
ID (required)
The index of the remote log destination to be deleted
Example
->remove log-target 3
Removes log-target index number 3
Item Description
set log-target
Modify the properties of an existing remote log destination.
Syntax
set log-target <ID> [Destination=<IpAddress|DNS>]
[Severity=<Critical|Error|Warning|Info>]
[Transport=<TCP|UDP>] [Port=<1-65535>]
[Security=<None|STunnel>] [Format=<RFC3164|ISO8601>]
[State=<Enabled|Disabled>]
Parameter
ID (required)
The index of the remote log destination whose configuration needs to be
modified
Properties
Destination
(optional)
The IpAddress or the DNS of the remote log destination that has been
configured
Severity (optional)
Severity of the log messages that should be sent to the specified destination.
Valid values include "Critical", "Error", "Warning", and "Info". The default
value is "Info".
Transport (optional) The transport protocol to be used for sending the log messages to the
destination. Valid values include "TCP" and "UDP". The default value is "UDP".