Virtual connect documentation – HP Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem User Manual
Page 9
Introduction 9
o
In VC 4.20, the VLAN Capacity is set to Expanded by default. You must do the following to add a
fresh VC 4.20 installation to your existing VCDG:
—
3.30-3.70 with Legacy VLAN VCDG—You cannot add the domain. Select a different VCDG.
—
3.30-3.70 with Enhanced VLAN VCDG—Add the domain as is. No change is required.
•
A server profile migration of a SAN-booted server between enclosures is not supported for SAN-boot
from a Direct-Attached 3PAR array.
Virtual Connect documentation
The following Virtual Connect documentation is available on the HP website
•
HP Virtual Connect for c-Class BladeSystem User Guide
This guide provides details for the Virtual Connect GUI, including descriptions of screen contents and
steps to set up domains, profiles, networks, and storage.
•
HP Virtual Connect for c-Class BladeSystem Setup and Installation Guide
This guide provides hardware installation and configuration information for initial setup of a Virtual
Connect solution. The guide also provides Virtual Connect module component and LED descriptions
and guidelines for module installation and upgrades.
•
HP Virtual Connect Manager Command Line Interface for c-Class BladeSystem User Guide
This guide provides information for using the Virtual Connect Command Line Interface, including use
scenarios and complete descriptions of all subcommands and managed elements.
•
HP Virtual Connect Ethernet Cookbook: Single and Multiple Domain (Stacked) Scenarios
This guide helps new Virtual Connect users understand the concepts of and implement steps for
integrating Virtual Connect into a network. The scenarios in this guide vary from simplistic to more
complex while covering a range of typical building blocks to use when designing Virtual Connect
solutions.
•
HP Virtual Connect Fibre Channel Networking Scenarios Cookbook
This guide details the concepts and implementation steps for integrating HP BladeSystem Virtual
Connect Fibre Channel components into an existing SAN fabric. The scenarios in this guide are
simplistic while covering a range of typical building blocks to use when designing a solution.
•
HP Virtual Connect with iSCSI Cookbook
This guide describes how to configure HP Virtual Connect for an iSCSI environment. It provides tips and
troubleshooting information for iSCSI boot and installation.
•
HP Virtual Connect FlexFabric Cookbook
This guide provides users with an understanding of the concepts and steps required when integrating
HP BladeSystem and Virtual Connect Flex-10 or FlexFabric components into an existing network.
•
FCoE Cookbook for HP Virtual Connect
This guide provides concept, implementation details, troubleshooting and use case scenarios of Fibre
Channel over Ethernet through FIP Snooping using FC-BB-5 with HP Virtual Connect.
•
HP BladeSystem c-Class Virtual Connect Support Utility User Guide
This guide provides instructions for using the Virtual Connect Support Utility, which enables
administrators to upgrade VC-Enet and VC-FC firmware and to perform other maintenance tasks