HP LaserJet 4300 Printer series - Manual (Page 107)

ENWW Clearing jams 105
6 Remove the jammed paper. If necessary, lift the black plastic guide
that is located on the top of the fuser to gain access to the jammed
paper. You can also turn the jam-clearing wheel that is located on
the side of the fuser to attempt to eject the jammed paper.
CAUTION
Do not use a sharp object to clear paper from the fuser area. You might
damage the fuser.
7 Push the fuser firmly into the printer until the blue levers on both
sides click into place.
8 Install the rear output bin. Pull gently on the bin to make sure that
the hinge pins are fully inserted.
9 Plug the power cord into the printer.
10 Replace the optional duplexer, if it was removed.
11 Turn the printer power on.
12 If a jam message persists, there is still jammed paper in the printer.
Look for the jam in another location. (See “Jam locations” on
page 96 .)
After clearing all jams, you will need to send the print job again because
the printer power has been turned off.
6
7
10
11
8
9