HP LaserJet 4300 Printer series User Manual
Page 118
116 4 Problem solving
ENWW
ENV FEEDER LOAD
[SIZE]
A job has been sent to the optional envelope feeder and the feeder is not loaded with the correct
envelope size.
1.
Load the correct size in the feeder.
2.
Make sure that the envelope size is set correctly on the Paper Handling menu at the printer
control panel. (See
“Paper Handling menu” on page 154
.)
3.
Pressing
P
AUSE
/R
ESUME
will prompt a question asking if you would rather print on another
available size of envelope in the printer. Use
U
P
ARROW
(
) or
D
OWN
ARROW
(
) to
scroll through the available sizes, and then press
S
ELECT
(
) to select one.
FLASH DEVICE
FAILURE
For help press
The flash DIMM had a critical failure and no longer can be used.
Remove the flash DIMM and replace it with a new one. (See
FLASH FILE OPERATION
FAILED
For help press
The requested operation could not be performed. You might have attempted an illegal
operation, such as trying to download a file to a non existent folder.
FLASH FILE
SYSTEM IS FULL
For help press
The flash DIMM is full.
Delete files from the flash DIMM. Use Device Storage Manager in HP Web Jetadmin to
download or delete files and fonts. (See the HP Web Jetadmin software Help for more
information.)
FLASH IS
WRITE PROTECTED
For help press
The flash DIMM is protected, and no new files can be written to it.
Use Device Storage Manager in HP Web Jetadmin to disable the write protection. (See the
HP Web Jetadmin software Help for more information.)
INSERT OR CLOSE TRAY [XX]
For help press
The specified tray is open or missing.
Insert or close the tray for printing to continue.
INSTALL CARTRIDGE
For help press
The print cartridge has been removed and must be reinstalled for printing to continue. Make
sure that the print cartridge is fully inserted.
INSTALL FUSER
For help press
The fuser is not fully seated or has been removed and must be reinstalled for printing to
continue.
1.
If the fuser is in the printer, remove and reinstall it. If the fuser is not in the printer, install it.
2.
Push the fuser firmly into the printer until the blue levers on both sides click into place.
WARNING!
The fuser is very hot. To avoid minor burns, wait 30 minutes for the fuser to cool before
removing it from the printer.
Message
Explanation or recommended action