HP Color LaserJet 3800 Printer series - Manual (Page 216)

6. Push down on the DIMM until both latches engage the DIMM.
NOTE If you have difficulty inserting the DIMM, make sure that the notch on the bottom of
the DIMM is aligned with the bar in the slot. If the DIMM still does not go in, make sure that
you are using the correct DIMM type.
7. Align the edge of the formatter board in the tracks at the top and bottom of the slot, and then slide
the board back into the printer. Push the formatter firmly until you hear the formatter latches click
into place.
8. Reconnect the power cable and USB or network cable, and then turn on the printer.
9. After installing a memory DIMM, see Enabling memory .
Enabling memory
If you installed a memory DIMM, set the printer driver to recognize the newly added memory.
To enable memory for Windows
1. On the Start menu, point to Settings, and click Printers or Printers and Faxes.
2. Select this printer and select Properties.
3. On the Configure tab, click More.
4. In the Total Memory field, type or select the total amount of memory that is now installed.
202 Appendix E Working with memory ENWW