HP 3PAR Operating System Software - Manual (Page 169)

12 Managing VLUNs
When working with VLUNs, the following actions are available:
“Exporting VLUNs” (page 169)
“Removing VLUNs” (page 169)
“Viewing VLUNs” (page 169)
Exporting VLUNs
To export a VLUN:
1.
In the Manager Pane, click Provisioning.
2. In the Common Actions Panel, click Export Volume.
The Export Virtual Volume wizard appears.
Export
1. In the General group box:
a.
System - Select a system from the list.
b. Domain - Select a domain from the list. If not applicable, select <none>.
2. In the Virtual Volume group box:
a.
Select either Virtual Volume or Virtual Volume Set.
b. From the virtual volume or virtual volume set list, select the volume(s) to export.
3. In the Export To group box:
a.
Select either Host (Host Sees) or Host Set (Host in Set).
b. From the host or host set list, select the host(s) you wish to export the virtual volumes to.
4. Click Next to go to the Summary page, or click Finish to complete the wizard.
Summary
Review the summary information, then click Finish.
Removing VLUNs
To remove a VLUN follow the instructions in “Unexporting Virtual Volumes” (page 150) .
Viewing VLUNs
To view system VLUNs:
1.
In the Manager Pane, click Provisioning.
2. In the Management Tree, click VLUNs under the system node you wish to view.
The VLUNs screen provides VLUN information on three tabs:, “VLUN Templates Tab” (page 99) ,
“Active VLUNs Tab” (page 99) , and “Path Summary Tab” (page 100) .
NOTE: In addition to providing comprehensive information about a system's VLUNs, the HP
3PAR Management Console also allows you to access the same type of information for Remote
Copy VLUNs by selecting the Remote Copy child node under the VLUNs node in the Management
Tree.
Exporting VLUNs 169