HP 3PAR Operating System Software - Manual (Page 211)

RC Ports Tab
The list pane of the RC Ports tab displays summary information about the system's Remote Copy
ports. The detail pane displays details about a selected port from the list pane.
The following information is displayed in the list pane:
Description Column
The location of the port in node:slot:port format. Position
The World Wide Name (WWN) or Media Access Control (MAC) address of the
connected device. WWN/MAC
The state of the port. See “System and Component Status Icons” (page 407) . State
The type of port, either Remote Copy over IP (RCIP) or Remote Copy over Fibre Channel
(RCFC). Type
Type of device that the port is connected to. Free, Disk, Host, Peer, RC, or InServ. Connected Device Type
Name of device that the port is connected to, e.g. host1, cage0. Connected Device
Port firmware mode setting. Ports in Initiator mode are connected to drive cages and
ports in Target mode export to hosts. Suspended mode is for target ports that have not
yet been initialized by the system (rare). Peer mode is for Ethernet ports. Mode
For information about the detail pane, see “RCIP Tab” (page 212) and “RCFC Tab” (page 213) .
Viewing Remote Copy Information 211