HP 3PAR Operating System Software - Manual (Page 275)

17 Locating a System
This operation helps locate a system by oscillating the node status LEDs amber and green on all
nodes of the system. If desired, the LEDs in all connected drive cages are also set to amber or
oscillate, depending on the drive cage type.
NOTE: This operation can only be performed by users with Super, Service, or Edit privilege
levels.
To locate a system:
1.
Click Systems in the Manager Pane.
2. From the Management Tree, right-click the system you wish to locate and then click Locate
System.
3. Specify a Duration for the LED(s) to oscillate. For EOS systems, the range is 1–3600 seconds,
with a default duration of 900 seconds. For other systems prior to EOS, the range is from 1
and 255 seconds, with a default of 60 seconds.
4. Optionally, if you want the drive cage LEDs to turn amber or oscillate as well, click the Include
Cage(s) checkbox.
5. Click OK to start the locate.
Once you have selected the Locate action, the Storage Systems tree node will be displayed and
the Storage Systems summary screen will list the currently connected systems. The locate icon will
flash next to the system being located for the duration specified.
You can stop a Locate operation by selecting Stop Locate instead of Locate System in Step 2 .
See also:
“Manager Pane” (page 396)
“Management Tree” (page 395)
“Locating Controller Nodes” (page 287)
Editing a System
You can edit the identification, identification information, properties, and alert settings for any
system connected to the HP 3PAR Management Console.
NOTE: Editing systems can only be performed by users with Super, Service, and Edit privilege
levels.
To edit a system, access the Edit System wizard.
Editing a System 275