HP 3000 Enterprise Virtual Array - Manual (Page 139)

A Command line interface
Command line interface for the mpx100/100b
This appendix contains information about using the CLI for mpx100/100b, including the command
syntax with examples.
mpx100/100b log-on, user accounts, and backup and restore
This section contains information about he logging on to a SAN mpx100/100b, mpx100/100b user
accounts, and backing up and restoring the mpx100/100b.
Logging on to a SAN mpx100/100b
To log on to an mpx100/100b using Telnet, open a command line window on the server, and then
enter the telnet command followed by the mpx100/100b management port IP address:
# telnet ip-address
A Telnet window opens prompting you for a login. Enter an account name and password.
To log on to a switch through the serial port, configure the server port with the following settings:
• 115200 baud
• 8-bit character
• 1 stop bit
• No parity
User accounts
The mpx100/100bs come from the factory with the following user account already defined:
Account name: guest
Password: password
For more information, see “ Commands ” on page 139 and “ Password command ” on page 149.
Backup and restore
Use the FRU command to back up and restore the mpx100/100b configurations. This backup will
protect your work and be useful as a template in configuring other mpx100's/100b's.
Commands
The mpx100/100b command syntax is as follows:
EVA iSCSI Connectivity User Guide 139