HP 3000 Enterprise Virtual Array - Manual (Page 212)

4. Select the CHAP Login Information checkbox.
5. Enter the CHAP secret for the mpx100/100b–discovered iSCSI Initiator in the Target Secret box.
6. Click OK and then click OK again.
Enabling single–direction CHAP during discovery and
bidirectional CHAP during normal session
Table 35 lists the parameters you need to enable single-direction CHAP during discovery and
bidirectional CHAP during normal sessions.
Table 35 CHAP single and bidirectional settings
MS Initiator secret settings mpx100/100b secret settings
hpstorageworks General Tab Secret N/A iSCSI Port
CHAPsecret0 Add Target Portal CHAPsecret01 Discovered iSCSI Initiator
CHAPsecret01 Log on to Target hpstorageworks iSCSI Presented Target
NOTE:
These are examples of secret settings. You must configure CHAP with settings that apply to your specific
network environment.
1. Enable CHAP for the mpx100/100b discovered iSCSI Initiator entry. Select one of the following
procedures, depending upon the interface you are using:
a. To enable CHAP for the mpx100/100b discovered iSCSI Initiator entry using HP Storage-
Works mpx Manager:
• If the iSCSI Initiator is not listed under Discovered iSCSI Initiators:
i. Go to the Wizard menu and select the Add Initiator Wizard and enter the iqn
name.
ii. Select the Enable CHAP check box.
iii. Enter a CHAP secret. For example:
CHAPsecret01
• If the iSCSI Initiator is already listed under Discovered iSCSI Initiators
i. Select the initiator in the left-hand column of the Discovered ISCSI Initiator list.
ii. Click the Information tab.
iii. Select the Enable CHAP check box.
iv. Enter a CHAP secret. For example:
CHAPsecret01
b. To enable CHAP for the mpx100/100b Discovered iSCSI Initiator entry using the
mpx100/100b CLI:
• If the iSCSI Initiator is not listed under the Show Initiators command:
i. Enter the initiator add command and add the iSCSI Initiator that is about to
do discovery.
ii. Enable CHAP and enter a CHAP secret. For example:
CHAPsecret01
Setting up authentication 212