HP 3000 Enterprise Virtual Array - Manual (Page 216)

• Using iSNS for Target discovery:
i. Click Add under iSNS Servers.
ii. Enter the IP address of the iSNS server.
iii. Click OK.
g. Click Targets.
h. Select the appropriate target for login.
i. Click Log On.
j. Click Advanced.
k. Select the CHAP Login Information check box.
l. Enter the CHAP secret for the mpx100/100b discovered iSCSI Initiator in the Target Secret
box. For example:
CHAPsecret01
m. Select the Mutual Authentication check box.
n. Click OK.
o. Click OK and the initiator completes normal login.
Enabling bidirectional CHAP during discovery and bidirectional
CHAP during normal session
Table 37 lists the parameters you need to enable bi–directional CHAP during discovery and
bidirectional CHAP during normal session.
Table 37 CHAP bidirectional and bidirectional settings
MS Initiator secret settings mpx100/100b secret settings
Hpstorageworks General Tab Secret hpstorageworks iSCSI Port
CHAPsecret01 Add Target Portal CHAPsecret01 Discovered iSCSI Initiator
CHAPsecret01 Log on to Target hpstorageworks iSCSI Presented Target
NOTE:
These are examples of secret settings. You must configure CHAP with settings that apply to your specific
network environment.
1. Enable CHAP for the mpx100/100b Discovered iSCSI Initiator entry. Select one of the following
procedures, depending upon the interface you are using:
a. To enable CHAP for the mpx100/100b Discovered iSCSI Initiator entry using HP Storage-
Works mpx Manager:
• If the iSCSI Initiator is not listed under Discovered iSCSI Initiators:
i. Go to the Wizard menu and select the Add Initiator Wizard and enter the iqn
name.
ii. Select the Enable CHAP check box.
iii. Enter a CHAP secret. For example:
CHAPsecret01
• If the iSCSI Initiator is already listed under Discovered iSCSI Initiators:
Setting up authentication 216