HP StorageWorks XP Remote Web Console Software - Manual (Page 105)

Table 34 Cause of Error and the Result of RAID Manager Command (SSB) (continued)
Cause of Error RAID Manager Command SSB2 SSB1
XP Snapshot S-VOL, the
command ends abnormally.
Since you specified the XP
Business Copy reserved All commands 975c
volume as the XP Snapshot
S-VOL, the command ends
abnormally.
Since you specified the XP
Auto LUN source volume as All commands 975d
the XP Snapshot S-VOL, the
command ends abnormally.
For information about using
XP Auto LUN, contact HP
technical support (see
(page 110) ).
Since you specified the XP
Auto LUN target volume as All commands 975e
the XP Snapshot S-VOL, the
command ends abnormally.
For information about using
XP Auto LUN, contact HP
technical support (see
(page 110) ).
Since you specified the XP
Auto LUN reserved volume All commands 975f
as the XP Snapshot S-VOL,
the command ends
abnormally.
For information about using
XP Auto LUN, contact HP
technical support (see
(page 110) ).
The XP Snapshot pair cannot
be created for any of the
following reasons: paircreate 9763
• The shared memory is not
increased.
•
Initialization is in
process.
Unavailable parameter
(unsupported parameter) is
specified in the command. paircreate 976a
Since the command was
executed with the PSUE pairsplit 976c
option, the snapshot data
cannot be stored.
When an XP Snapshot P-VOL
and XP Continuous Access pairsplit 976e
S-VOL share the volume, the
status of the XP Continuous
Access pair is COPY.
Therefore, the snapshot data
cannot be stored.
When XP Snapshot P-VOL
and XP Continuous Access pairsplit 976f
Troubleshooting When Using XP RAID Manager 105