Configuring an iscsi initiator in vmware – HP QLogic QMH4062 1GbE iSCSI Adapter for c-Class BladeSystem User Manual
Page 10
Setup 10
15.
Select 6: Add a Target.
16.
Complete the interactive list of settings as follows:
a.
IPv6 Target? [off]: Press the Enter key to accept the default.
b.
TGT_iSCSI_Name []: Enter the IQN of the iSCSI target to connect to, and then press the Enter
key.
c.
TGT_Port [3260]: Press the Enter key to accept the default.
d.
TGT_TargetIPAddress [0.0.0.0]: Enter the IP address of the target, and then press the Enter
key.
17.
Select 12: Save Target/CHAP Changes on the options menu.
This completes the iSCSI initiator configuration for connecting to the iSCSI target.
Configuring an iSCSI Initiator in VMware
Enable the iSCSI initiator software so that ESXi can use it to access iSCSI storage.
To configure an ESX/ESXi initiator:
1.
Log in to the vSphere Client.