Setup, Setting up qcc on a management server, Downloading and installing qcc – HP QLogic QMH4062 1GbE iSCSI Adapter for c-Class BladeSystem User Manual
Page 5: Iscsi initiator, Configuring an iscsi initiator in linux
Setup 5
Setup
Setting up QCC on a management server
Set up QCC on only one management server in your network to manage all CNAs, and complete the QCC
installation before installing drivers or updating firmware. Use QCC to manage CNAs instead of SANsurfer
(QLogic HBA management application).
Downloading and installing QCC
Download and install QCC on Windows and Linux operating systems.
To locate and download the QCC application:
1.
Go to the HP website
2.
Click Drivers and downloads.
3.
Enter the CNA model number. Use the HP model number as your guide.
4.
Select the operating system.
5.
Select the QCC application, and then download it to the server.
To download the QCC agent, repeat steps 1 through 4, and then select QCC agent.
iSCSI initiator
Use the following information to configure iSCSI Initiator on the appropriate operating system.
Configuring an iSCSI Initiator in Linux
1.
Enter gaucli in a terminal window to access the QCC CLI.
2.
Select 2: Adapter Configuration on the QConvergeConsole CLI Main Menu.
3.
Select 1: CNA Configuration on the Adapter Type Configuration Selection menu.
4.
Select 1: CNA iSCSI Configuration on the CNA Protocol Type Selection menu.
5.
Select 3: Port IP Settings on the CNA iSCSI Configuration menu.
6.
Select the converged network port you want to configure.
7.
Select 2: Configure IP Settings. If you have already used Fast!Util to configure IP settings, this
information is already populated.
8.
Complete the interactive list of settings as follows:
a.
Enable IPv4 [on]: Press the Enter key to accept the default.
b.
DHCP to obtain IPv4 Network Information: [off]: Press the Enter key to accept the
default. To enable DHCP, enter ON, and then press the Enter key.
c.
IP_Address []: Type the IP address of the initiator system, and then press the Enter key.