HP QLogic QMH4062 1GbE iSCSI Adapter for c-Class BladeSystem User Manual
Page 8
Setup 8
6.
Select the converged network port you want to configure.
7.
Select 2: Configure IP Settings if you need to configure IP Settings. If you have configured this using
Fast!UTIL, the IP address field is already populated.
8.
Complete the interactive list of settings as follows:
a.
Enable IPv4 [on]: Press the Enter key to accept the default.
b.
DHCP to obtain IPv4 Network Information: [off]: Enter ON, and then press the Enter
key. Select DHCP, and then press the Enter key.
c.
Enable IPv6 [off]: Press the Enter key to accept the default. If you are using a static address,
set DHCP to obtain IPv4 network information to OFF.
d.
IP_Address []: Enter the IP address of the initiator system, and then press the Enter key.
e.
IP_Subnet_Mask [255.255.255.0]: Enter the appropriate subnet mask, and then press the
Enter key.
f.
IP_Gateway [0.0.0.0]: Press the Enter key to accept the default or enter the address of the
default gateway.