HP StorageWorks XP Remote Web Console Software - Manual (Page 17)

NOTE:
◦ The WLMPAV parameter value is not relevant when using Compatible Hyper PAV.
◦ To use Compatible Hyper PAV, both the Compatible PAV software and the Compatible
Hyper PAV software must be enabled on the Remote Web Console. For information on
how to install the Compatible PAV and Compatible Hyper PAV software, see the HP
StorageWorks XP24000/XP20000 Remote Web Console User's Guide.
◦ You can use the Compatible PAV window to check the capacity available to the
Compatible PAV base volume. The used capacity is the sum of capacity of the volumes
that meet one or more of the following conditions:
– The base volume to which alias volumes are or were assigned by using Remote Web
Console.
– The base volume which alias volumes access or accessed by using dynamic
Compatible PAV or Compatible Hyper PAV.
The base volume that is recognized as the object for calculation of used capacity is
not be calculated as used capacity if all the assigned aliases in the corresponding
CU are cancelled, or uninstall the volumes by using LVI/LUN (VLL) or HP
StorageWorks XP External Storage Software.
Table 3 (page 17) lists the requirements and restrictions for Compatible PAV operations on the
storage system. The requirements and restrictions depend on whether you use Compatible PAV or
Compatible Hyper PAV.
If you use both Compatible PAV and Compatible Hyper PAV, conform to the requirements and
restrictions for using Compatible Hyper PAV.
Table 3 Requirements and Restrictions for Compatible PAV
Requirement and/or Restriction Item
Compatible Hyper PAV Compatible PAV
I-2107 I-2105, I-2107 Controller emulation type
3380-3
3390-3, 3390-9, 3390-L, 3390-M
3380-3
3390-3, 3390-3R, 3390-9, 3390-L,
3390-M
Data Exchange Software devices listed
below are not supported.
3380-3A, 3380-3B, 3380-3C
3390-3A, 3390-3B, 3390-3C
3390-9A, 390-9B, 3390-9C
3390-LA, 3390-LB, 3390-LC
3390-MA, 3390-MB, 3390-MC
Device emulation type for base device
FICON ESCON, FICON Channel interface
One SSID must be set for each set of 256 LDEVs. Storage subsystem ID (SSID) setting
255 Maximum number of aliases that can
be assigned to a base device
Alias device and its base device must belong to the same LCU image. Alias device
System Requirements 17