HP OneView - Manual (Page 105)

12 Quick Start: Configuring an enclosure and server blade
for Direct attach to an HP 3PAR Storage System
This quick start describes the process for adding and configuring an enclosure so that its servers
can connect to an HP 3PAR Storage System that is directly attached to the enclosure.
For a step-by-step illustrated example of this scenario (except that configuring the enclosure group
and logical interconnect occurs during the enclosure add operation), see
“Configuring a server
blade to boot from the attached HP 3PAR Storage System” (page 256) .
Prerequisites
•
Minimum required privileges: Infrastructure administrator or Network administrator for adding
the networks.
•
Minimum required privileges: Infrastructure administrator or Server administrator for adding
the enclosure and server profiles.
•
The HP 3PAR Storage System is installed and configured and the cables are attached to the
enclosure you want to use.
•
See “Prerequisites for bringing an enclosure under management” (page 131) for prerequisites
and preparation you must complete before you add an enclosure.
•
See “Prerequisites for bringing server hardware under management” (page 112) for prerequisites
and preparation you must complete before you add a server.
105