HP LaserJet 9000 Printer series - Manual (Page 130)

7 Problem solving 130
Understanding product messages
21 PAGE TOO
COMPLEX
alternates with
To continue touch
Continue
The page formatting process was not fast enough for the product.
Touch Continue to print the transferred data. (Some data might be lost.)
The page protection item appears in the CONFIGURE DEVICE - DEFAULTS - EVENTS menu, and
should be set to ON to print the page. When the page is successfully printed, PAGE PROTECT=ON ,
should be set back to AUTO (see “System setup submenu” on page 205 ).
If this message appears often, simplify the print job.
22 EIO x
BUFFER OVERFLOW Too much data was sent to the EIO card in the specified slot ( x ). An improper communications
protocol might be in use.
Touch Continue to print the transferred data. (Some data might be lost.)
Check the host configuration. If this message persists, contact an HP-authorized service or
support provider. (see the introduce guide on the product CD, or go to
www.hp.com/suppor t/lj9000 .)
22 PARALLEL I/O
BUFFER OVERFLOW
alternates with
To continue touch
Continue
Too much data was sent to the parallel port.
Check for a loose cable connection, and be sure to use a high-quality cable.(see the introduce
guide on the product CD, or go to
www.hp.com/suppor t/lj9000 ). (Some non-HP parallel cables
might be missing pin connections or might otherwise not conform to the IEEE-1284
specification.)
This error can occur if the driver you are using is not IEEE-1284 compliant. For best results, use
the HP driver that came with the product (see
“Drivers” on page 16 ).
Touch Continue to clear the error message. (Data will be lost.)
If this message persists, contact an HP-authorized service or suppor t provider (see the
introduce guide on the product CD, or go to
www.hp.com/suppor t/lj9000 ).
22 SERIAL I/O
BUFFER OVERFLOW The product serial buffer has overflowed during a busy state.
Touch Continue to print the transferred data. (Some data might be lost.)
Message Explanation or recommended action