HP ProLiant DL160 Gen8 Server - Manual (Page 36)

Hardware options installation 36
7. Connect the Mini-SAS cable from the Smart Array controller to the hard drive backplane.
8. Install the processor air baffle (on page 20 ).
9. Install the access panel (on page 19 ).
10. Slide the server into the rack.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server (on page 16 ).
VGA power cable option
1. Power down the server (on page 16 ).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 17 ).
o Remove the server from the rack (on page 16 ).
4. Remove the access panel (on page 19 ).
5. Remove the processor air baffle (on page 20 ).