HP ProLiant DL160 Gen8 Server - Manual (Page 64)

Hardware options installation 64
b. Tighten the thumbscrew.
11. Install the PCI riser cage (on page 22 ).
12. Install the processor air baffle (on page 20 ).
13. Install the access panel (on page 19 ).
14. Slide the server into the rack.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server (on page 16 ).
Common slot power supply option
IMPORTANT: The DC power supply unit must only be installed by a qualified technician.
• The 14 AWG green or yellow wire must be fastened to the metal enclosure with a screw and
a spring or star washer.
• When installing the DC power supply unit, the ground wire must be connected before the
positive or negative leads.
To install the component:
1. Unfasten the cable management solution to access the power supply bays.