HP NC550SFP Dual Port 10GbE Server Adapter - Manual (Page 28)

Configuring and managing iSCSI targets 28
By pressing F3, you can set the Boot LUN if the target is a boot target. By setting the LUN to bootable you
can confirm that you have the boot target configured properly and see from which LUN you are booting.
By reviewing the LUN size, you can determine the LUN order. The target gives the LUN order in the LUN
order listed.
The BladeEngine 2 controller supports a maximum of 8 LUNs on a boot target. If you select LUNs further
down on the list, the first LUN is used as the boot LUN.
If there are no LUNs available, the following message displays:
No LUN available, please check your configuration on the Target.
Removing a target
After a target is configured, it may need to be removed or you may just want to log out of the target.
To remove or delete a target means to log out of the target and remove it from the list of targets. To log
out of a target means to log out of the target but the target is still listed in the target list with the connection
status of Disconnected.
To delete a target, logout, or login, complete the following:
1. To delete the target, from the iSCSI Target Configuration menu, select the target and press Delete.
2. To log out of the target, from the iSCSI Target Configuration menu, select the target and press F6.
3. To log into the target, from the iSCSI Target Configuration menu, select the Disconnected target and
press F5 to establish the target session.
Booting the system
After you have successfully configured the iSCSI initiator and target, you must reboot the system for the
configurations to take affect.
When you exit HP NC-Series ServerEngines iSCSISelect, the system automatically reboots and during
system startup, the adapter's BIOS displays.
ServerEngines iSCSI Initiator BIOS v2.100.500.0
(c) 2005-2009 ServerEngines Corporation. All Rights Reserved.
(c) 1998-2005 Adaptec, Inc. All Rights Reserved.
Controller#0 Port#0 Base 0xFCE60000 at Bus:01 Dev:00 Fun:02
Controller#0 Port#1 Base 0xFCEA0000 at Bus:01 Dev:00 Fun:03
Press <Ctrl><S> for iSCSISelect(TM) Utility
Initiator iSCSI Name: iqn.2004-05.com.serverengines.be2
Initiator IP Address: 172. 40. 1.41
Initiator IP Address: 172. 40. 1.62
BIOS Not Installed.
The iSCSI BIOS logs into the configured iSCSI boot target and displays its target/LUN information in the
BIOS sign-on banner only if an iSCSI boot target is configured.
Erasing the configuration
With the Erase Configuration option, you can erase the configuration of a single controller.