HP Storage Mirroring Software - Manual (Page 273)

271 of 739
was created before any of the routable IP resources, the Application
Manager will fail to enable protection. To enable protection, you will need
to delete the non-routable IP resource(s), re-create them, and then re-add
them as dependencies on the network name resource for the virtual server
A source server can have a Protected status only if the source is currently connected to a
target and an Application Manager-generated replication set exists. The following table
lists the Application Manager-generated replication set names.
Application Replication set name
Exchange xdag01_<source server name>_<target server name>
SQL sqldag01_<source server name>_<target server name>
File server fileprint_<source server name>_<target server name>
SharePoint BB_<source server>_<target server>
BlackBerry SharePointdag01_<source server name>_<target server name>
While there may be other Storage Mirroring Recover connections between the selected
source and target, Application Manager only recognizes connections that it has created.
Any connection that has been built by Application Manager will be recognized as a valid
connection, regardless of the connection state.
Note:
If you modify your configuration on the source server (such as adding a new
storage group or database to a directory that was not included in the replication
set), you must disable protection, run validation and fix any issues, then re-
enable protection to apply the changes to the Application Manager replication
set.
Next step: Failover
Disable protection
If you have not done so already, launch the Storage Mirroring Recover Application
Manager by selecting Start, Programs, HP Storage Mirroring, Recover, Storage Mirroring
Recover Application Manager.
You can disable an existing Application Manager-generated source/target connection
monitor within the Application Manager.