HP Storage Mirroring Software - Manual (Page 350)

348 of 739
d. Click OK to save the changes.
e. Repeat these steps on each node of the cluster(s).
6. If your source is a standalone server, establish your connection through the
Connection Manager , selecting the virtual server network name for the Target
Server and the virtual server IP address for the Route.
7. If your source is a cluster, establish your connection by creating and bringing
online a Double-Take Source Connection resource. These instructions will vary
depending on your operating system.
Establishing your connection on Windows 2003
a. From the Cluster Administrator, right-click on the group and virtual server you
are protecting and select New, Resource.
b. Specify the following fields on the New Resource dialog box.
●
Name—Specify a name that indicates this is the Storage Mirroring
Recover virtual server connection.
●
Description—You can optionally add a more detailed description for
this resource.
●
Resource type—Specify Double-Take Source Connection.
●
Group—The resource group name should be selected. If it is not,
select the correct group name.
c. Click Next to continue.
d. Verify that all of the cluster nodes appear as Possible Owners and click
Next to continue.
e. The resource is dependent on the physical disk and network name
resources. Select these two resources so that the Double-Take Source
Connection resource is dependent on both of them. Click Next to continue.
f. Specify your Storage Mirroring Recover connection parameters.