HP LASERJET PRO P1102w - Manual (Page 110)

Page skew
● Make sure that the media is loaded correctly and the
media guides are not too tight or too loose against the
media stack.
● The input bin might be too full.
● Check the media type and quality.
Curl or wave
● Check the media type and quality. Both high temperature
and high humidity cause media to curl.
● The media might have been in the input tray too long.
Turn over the stack of media in the tray. Also, try rotating
the media 180° in the input tray.
● The fuser temperature might be too high. In the printer
driver, make sure that the appropriate media type is
selected. If the problem persists, select a media type that
uses a lower fuser temperature, such as transparencies or
light media.
Wrinkles or creases
● Make sure that media is loaded properly.
● Check the media type and quality.
● Turn over the stack of media in the tray. Also, try rotating
the media 180° in the input tray.
● For envelopes, this can be caused by air pockets inside
the envelope. Remove the envelope, flatten the envelope,
and then try printing again.
96 Chapter 8 Solve problems ENWW