HP LASERJET PRO P1102w - Manual (Page 95)

Table 8-2 Control-panel light patterns (continued)
Light status State of the product Action
Ready light is blinking, and attention
light is off. The product is receiving or processing
data. No action is required. The product is
receiving or processing a print job.
Attention light is blinking, and ready
light is off. The product has experienced an error
that can be corrected at the product, such
as a jam, an open door, the absence of
a print cartridge, or the absence of paper
in the proper tray. Inspect the product, determine the error,
and then correct the error. If the error is
the absence of paper in the proper tray
or the product is in a manual feed mode,
put the proper paper in the tray and
follow the onscreen instructions, or open
and close the print-cartridge door to
resume printing.
Attention light is blinking, and ready
light is on. The product has experienced a continual
error from which it will recover on its
own. If the recovery is successful, the product
continues to the processing data state
and completes the job.
If the recovery is unsuccessful, the
product continues to the continuable
error state. Try removing any media from
the media path and turning the product
power off, and then on again.
The attention and ready lights are on. The product has experienced a fatal error
from which it cannot recover. 1. Turn off the product or disconnect
the power cord from the product.
2. Wait 30 seconds, and then turn on
the product or reconnect the power
cord to the product.
3. Wait for the product to initialize.
If the error persists, contact HP customer
support. See
Customer support
on page 115 .
ENWW Interpret control-panel light patterns 81