HP LASERJET PRO P1102w - Manual (Page 82)

Replace the separation pad
Normal use with good media causes wear. The use of poor media might require more frequent
replacement of the separation pad.
If the product regularly pulls multiple sheets of media at a time, you might need to change the
separation pad.
NOTE: Before you change the separation pad, clean the pickup roller. See Clean the pickup roller
on page 71 .
WARNING! Before changing the separation pad, turn the product off, disconnect the power cord
from the wall outlet, and then wait for the product to cool.
1. Disconnect the product power cord from the product.
2. Remove the paper and close the input tray. Set the product on its front.
3. At the bottom of the product, unscrew the two screws holding the separation pad in place.
68 Chapter 7 Manage and maintain the product ENWW