HP LASERJET PRO P1102w - Manual (Page 46)

Set or change the network password
Use the embedded Web server to set a network password or change an existing password.
1. Open the embedded Web server, click the Networking tab, and click the Password link.
NOTE: If a password has previously been set, you are prompted to type the password. Type the
password, and then click the Apply button.
2. Type the new password in the Password box and in the Confirm Password box.
3. At the bottom of the window, click the Apply button to save the password.
IP address
The product IP address can be set manually, or it can be configured automatically using DHCP, BootP,
or AutoIP.
To change the IP address manually, use the HP Embedded Web Server.
1. Open the HP Embedded Web Server, and then click the Networking tab.
2. In the navigation pane, click the IPv4 Configuration link or the IPv6 Configuration link.
3. In the IP Address Configuration section, click the Manual IP option.
4. Type the required data in the Manual IP Address box, the IP Subnet Mask box, and the
Manual Default Gateway box.
5. Click the Apply button.
Link speed setting
Use the Networking tab in the HP Embedded Web Server to set the link speed if necessary. The
setting is on the Advanced page.
Incorrect changes to the link speed setting might prevent the product from communicating with other
network devices. For most situations, leave the product in automatic mode. Changes can cause the
product to turn off, and then on. Only make changes when the product is idle.
32 Chapter 4 Connect the product ENWW