HP StorageWorks ESL9000 Tape Library - Manual (Page 57)

Preparing the Library for Operation
57 HP StorageWorks ESL9000 Series Tape Library User Guide
Turning the Library On and Off
Turning the Library On
To turn the library on:
1. Verify that:
a. All front doors and access panels are closed.
b. All back panel cable connections are firmly in place.
Note: If there are two AC power distribution assemblies, there will be two main circuit
breakers.
2. Ensure that CB1 on the AC distribution assembly is turned on. It is located in
the base of the cabinet behind the rear access panel. If two AC distribution
assemblies are present, turn on CB1 for both assemblies.
3. Turn on the power switch located below the control panel.
4. After several seconds, the control panel becomes active and the Home screen
appears. The POST routine and inventory routine also run. These routines can
take up to nine minutes to complete.
Placing the Library On-line or Off-line
With library turned on, press the Standby button on the control panel. Pressing
the Standby button toggles the library between on-line and off-line states.