HP StorageWorks ESL9000 Tape Library - Manual (Page 86)

Operator Commands
86 HP StorageWorks ESL9000 Series Tape Library User Guide
2. Identify the source element of the cartridge:
a. Press the appropriate source element button (Storage Bin, Drive, Load
Port, Gripper, or PTM). When you press an element type, the Range
box (below the Dest. box) displays the range of addresses.
b. Using the keypad, enter the address of the source element and then press
the Select button. The Source information is displayed in the Source box
and the Dest. box becomes active.
3. Identify the destination for the cartridge:
a. Press the appropriate destination element button (Storage Bin, Drive,
Load Port, Gripper, or PTM).
b. Using the keypad, enter the address of the destination element and then
press the Execute button. The Dest. box displays the destination
information and the move is initiated.
The control panel displays a Command In Progress dialog box with an Abort
button. The Move Cartridge command continues until completed unless you
press the Abort button to stop the operation.