HP StorageWorks ESL9000 Tape Library User Manual
Page 95
Maintenance and Troubleshooting
95
HP StorageWorks ESL9000 Series Tape Library User Guide
A Move command
failed.
■
Check the source and destination. The source should
hold the cartridge to be moved, and the destination
should be empty.
■
Make sure the gripper is empty and all actuators are
free of obstruction.
■
Make sure the library is on-line and the
Stop
button
is released.
■
Retry the command.
A flash memory error
is reported.
Contact your HP service representative.
A maximum
temperature exceeded
warning appears.
■
Ensure that the rear access panels are closed.
■
If the ambient temperature is too warm, then lower the
room temperature (see “
”
■
Make sure the three fan units are operational; the
Normal
LEDs should be lit.
■
Check temperatures and fan speed using the control
panel System Monitor functions.
■
Make sure that the air filter is clean.
■
Ensure that there are no obstructions to the air flow at
the fan inlet or exhaust.
■
Turn off the library and allow it to cool down. Lower
the room temperature, if possible, and increase
ventilation around the library.
Note:
If the operating temperature is too high, the library
will automatically shut down until the temperature drops.
Table 17: Operating Problems (Continued)
Problem
Corrective Action