HP StorageWorks ESL9000 Tape Library - Manual (Page 83)

Operator Commands
83 HP StorageWorks ESL9000 Series Tape Library User Guide
Calibrating the Library
The Calibrate Library command lets you calibrate the storage bins, the tape
drives, the load port, or the entire library. Calibrate the library during initial
installation and after any maintenance procedure.
To calibrate library elements:
1. From the Operator page, press the Calibrate Library button. The control
panel displays the Calibrate Library screen (see Figure 33 ).
2. Press the button for the calibration option you want.
Note: Pressing the Calibrate All button causes the drives, bins, and the load port to be
calibrated. This operation takes approximately 20 minutes.
The control panel displays a Command In Progress screen while the
calibration process is in progress.
3. When the calibration process is complete, repeat step 2 to perform another
calibration, if desired.
Figure 33: Calibrate library screen