HP Designjet L25500 Printer series - Manual (Page 15)

3 Basic setup options
Printer setup options
Turn the printer on and off
To turn on the printer, ensure that the power switch at the rear of the printer is turned on, ensure that
the residual current circuit breakers are in the up position, then press the
Power button on the front
panel. You can leave the printer on without wasting energy. Leaving it on improves response time. When
the printer has not been used for a certain period of time, it saves power by going into sleep mode. Any
interaction with the printer returns it to active mode, and it can resume printing immediately.
If you want to turn the printer on or off, the normal and recommended method is to use the Power button
on the front panel.
When you turn off the printer this way, the printheads are automatically stored with the printhead cleaning
cartridge, which prevents them from drying out.
However, if you plan to leave the printer turned off for a long period of time, you are recommended to
turn it off using the
Power button, and then also turn off the power switch at the rear.
To turn it back on later, use the power switch at the rear, and then press the Power button.
When the printer is turned on, it will take about ten minutes to initialize itself.
ENWW Printer setup options 11
Basic setup
op
tion
s