HP Designjet L25500 Printer series User Manual
Page 24
options > Enable narrow substrate. With this option, print quality is not guaranteed. To load a roll of
textile material see
Loading textile types of media on page 36
1.
At the printer's front panel, select the icon, and then select Substrate load > Load roll.
Alternatively, feed paper into the printer until the printer grasps it. The front panel will guide you
through the following steps.
2.
Carefully insert the leading edge of the substrate above the black-ribbed roller, making sure the
substrate remains taut during the process. Avoid pulling excess substrate from the roll, which could
cause skew. Also avoid rewinding the substrate manually, unless the printer asks you to do so.
WARNING!
Take care not to touch the rubber wheels on the platen while loading substrate.
These wheels can rotate and trap skin, hair or clothing.
WARNING!
Take care not to push your fingers inside the printer's substrate path.
The printer beeps when it detects and accepts the leading edge of the substrate.
3.
Select the substrate category of the roll you are loading.
NOTE:
You should select the name of the particular substrate that you are using in your RIP
software, not in the front panel.
NOTE:
The RIP substrate setting will overwrite the front panel setting.
TIP:
When loading very thin or very thick substrates, you should follow the manual loading
procedure to reduce the risk of substrate jams and printhead crashes
20
Chapter 4 Handle the substrate
ENWW
Handle the su
bstrate