HP Designjet L25500 Printer series User Manual
Page 25
4.
If the roll of media you are loading is new, select the length in the front panel. If the media has been
used before, and the tracking feature was used, select the media remaining. For information of the
media length tracking feature see
Media Length Tracking Feature on page 38
5.
The printer checks the substrate in various ways and may ask you to correct problems with skew
or tension.
NOTE:
You can specify the maximum permitted amount of skew at the front panel: select the
icon, then select Substrate handling options > Max skew setting.
6.
Wait until the substrate emerges from the printer, as shown in the following graphic.
NOTE:
If you have an unexpected problem at any stage of the substrate loading process, see
the Maintenance and troubleshooting guide.
7.
The printer calibrates the substrate advance.
8.
If you are loading transparent substrate without opaque borders, you are asked to enter the width
of the substrate and the distance of the right edge from the printer's side plate (as indicated by the
ruler on the front of the curing module).
9.
The printer indicates that it is ready for printing.
Take care not to cover the fans.
ENWW
Load a roll into the printer (automatically)
21
Hand
le the su
bstrate