HP Designjet L25500 Printer series User Manual
Page 35
14.
Ensure that once the media is correctly aligned with the blue stop and the right spindle hub, they
are both locked in position. Shown below is the media correctly aligned with the blue stop and the
right spindle hub.
15.
Pull the substrate taut to the position shown in the following figure. Do not attempt to pull more
substrate out of the printer. Use tape to secure the substrate to the spindle core, taping it in the
center first. You may need to use more tape than is shown in the following image. The substrate
should be secure enough to support the weight of the loop-shaping core, which you insert in a later
step.
NOTE:
If you are loading the take-up reel during printing you do not need to pull the substrate
taut. Tape the substrate to the spindle core when an adequate length of substrate has fed from the
printer after printing begins.
NOTE:
To avoid having the substrate skew as it winds onto the spindle core, make sure the
substrate is straight when you attach it, and aligned with the input roll. It is sometimes useful to use
the core grooves to align the substrate.
16.
Press the
OK
button on the front panel. The printer advances the substrate.
ENWW
Use the take-up reel
31
Hand
le the su
bstrate