HP ProLiant BL680c G7 Server-Blade - Manual (Page 22)

Operations 22
7. Remove the front panel/hard drive cage assembly.
Remove the front panel/hard drive cage assembly
(B-side)
To remove the component:
1. Power down the server blade (on page 16 ).
2. Remove the server blade (on page 17 ).
3. Place the server blade on a flat, level surface with the correct side of the server blade facing up. To
determine the correct side, see the label attached to the access panel.
4. Remove the access panel (B-side) (on page 18 ).
5. Disconnect the signal cable and power cable from the SAS backplane.
6. Loosen the thumbscrews.