HP ProLiant BL680c G7 Server-Blade User Manual
Page 62
Hardware options installation 62
CAUTION:
Always wear an antistatic wrist strap when working inside the server.
To install the component:
1.
Power down the server blade (on page
2.
Remove the server blade (on page
3.
Place the server blade on a flat, level surface with the correct side of the server blade facing up. To
determine the correct side, see the label attached to the access panel.
4.
Remove the access panel (A-side).
5.
Remove the mezzanine connector cover.
6.
Align the mezzanine connector on the optional mezzanine card with the mezzanine connector on the
system board.
CAUTION:
To prevent damage to the server blade, apply pressure over the mezzanine
connector when installing the mezzanine card. Do not apply pressure to the edges of the card.