HP DesignJet 500 - Manual (Page 158)

Media & Ink Introduction Front-Panel Other Index Solutions
The Front-Panel Setup Menus Consumable Menus Internal Prints Navigation
Message
Descriptions
Printer
Options
Lift window to remove
printheads You have selected replace
printheads and the front-
panel is guiding you through
the procedure. To see an animation of the
printhead installing procedure
see
Printhead Installation
Lift window to replace
SETUP printheads The printer is prompting you
to lift the window of the
printer so that you can
install ‘normal’ printheads
into the printer. you must
only remove the Setup
printheads when you have
initialized the printer first. It is vital to the correct
functioning of your printer, that
the Setup procedure is
performed correctly. Use the
Setup Instructions which came
with your printer to guide you
through the steps.
Media loaded incorrectly.
Remove media. The media is mis-positioned
or mis-aligned. Before the printer can continue
you must remove the media.
See
Loading Roll Media .
Media misaligned.
1_ Lift lever
2_ Align Media with
both edges of roll
3_ Lower lever The printer is helping you
with the load roll media
procedure. For an animation on the
loading roll procedure see
Loading Roll Media
Media misaligned.
1_ Lift lever
2_ Align right edge
with blue line
3_ Lower lever The media is not being fed
into the printer straight. For guidelines on loading
media see
Loading Roll Media
Guidelines
Status Description Procedure