HP Surestore Disk Array 12h and FC60 - Manual (Page 395)

Disk Enclosure Modules 395
Re
m
o
v
a
l a
n
d
R
ep
lac
eme
n
t
Figure 98 Disk Enclosure Power Supply Module Removal and Replacement
Installing the Power Supply Module
1. With the handle down, slide the replacement power supply into the empty slot (D in
Figure 98 ). The supply begins to engage the backplane with 3/8 inch (8 mm) still
exposed.
2. Swing the handle upward to seat the power supply into the backplane. The power
supply should be flush with the chassis.
3. Tighten the screw (B) in the power supply handle (A ).
4. Plug the power cord into the power supply and electrical source.
5. Check the Power Supply LED. It should then turn green. If the LED remains off or is
amber, see chapter 6, Troubleshooting for information on identifying and solving the
problem.
A - cam handle
B - locking screw
C - power supplies
D - power supply slot