HP Insight Management Agents - Manual (Page 72)

Agent information 72
• Advanced Memory Protection Condition—displays the current condition of the Advanced Memory Protection
subsystem. The following states are supported:
• Other—The system does not support fault tolerant memory or the Management Agent cannot determine the
state.
• OK—This system is operating normally.
• Degraded— The Advanced Memory Protection sub-system has been engaged. Schedule server down time to
replace the deactivated memory.
ROM Microcode Patches
This section displays the following information about ROM Microcode Patches:
• Patch ID—Displays the number of a particular microcode patch.
• Date—Displays the date of a patch's manufacture.
• Family—Specifies the valid family, model, and step that applies to a patch.
• Model—Displays the model number of a patch.
• Step—Displays the revision level of a patch.
General I/O Devices
This section displays information about the following I/O devices:
• Keyboard Type—Describes the keyboard attached to your monitored system. For example, 101-key
Enhanced Keyboard.
• Video Type—Describes the type of video in use with the monitored system. For example, EGA or VGA may
appear here.
• Auxiliary Input —Indicates whether the auxiliary input (pointing device or mouse port) is enabled or
disabled. If you have an EISA-based machine, use the System Configuration Utility to change this value. If
you have an ISA-based machine, use SETUP to change this value.
• Diskette Drives—This section lists and describes the device diskette drives.
• Serial and Parallel Ports—This section displays the serial ports and the parallel ports that have been enabled for
this unit, along with their corresponding I/O addresses. The industry-standard addresses for parallel ports are
as follows:
• Primary Port set to 378h
• Secondary Port set to 3BCh
• The industry-standard addresses for serial ports are as follows:
• COM1 set to 3F8h
• COM2 set to 2F8h
These addresses are sometimes changed due to conflicts with another device. Communication ports that
have been disabled do not show up in this window.
• Universal Serial Bus Port—This section displays the Universal Serial Bus (USB) ports that have been enabled for
this unit.
• Memory Modules—This section lists detailed information about the memory boards and modules installed in the
system. The following items may be displayed:
• Socket Number—displays the socket number for the memory module.
• Type—displays the following values depending on the type of memory module selected.
• Not installed
• Board—The memory module is permanently mounted (not modular) on a system board or memory
expansion board.
• Single width module
• Double width module
• SIMM (Single Inline Memory Module)
• PCMCIA (Personal Computer Memory Card International Association technology memory module)
• Compaq/HP specific memory module
• DIMM (Dual Inline Memory Module)
• Size—Displays the size of the memory module.
• Speed—Displays the speed of the memory module.
• Technology—Displays the possible values for the memory module technology, including: