GE ZDP364NDPSS - Manual (Page 14)

IMPORTANT: Disconnect the range and the
individual shut-off valve from the gas supply piping
system during any pressure testing of that system
at test pressures greater than 1/2 psig. Isolate the
range from the gas supply piping system by closing
the individual manual shut-off valve to the range
during any pressure testing of the gas supply piping
system at test pressures equal to or less than
1/2 psig.
NOTE: This range is equipped with a gas shut-off
valve located on top of the range, beneath the rear
vent. This shut-off valve is to be used in the event
that service is required in the future.
CONNECT RANGE TO GAS
WARNING
Do not use a flame to check for gas leaks.
Assure that gas supply is turned off
at the shut-off valve:
• Apply pipe thread sealant to the gas inlet located
at the back of the range. Install the 1/2” pipe
elbow (provided) to the gas inlet.
• Connect 5/8” O.D. flexible metal connector
to gas inlet. Connect the other end of the flexible
connector to the house gas supply.
• Turn on the gas and check for leaks:
– Use a liquid leak detector at all joints
and connections in the system.
STEP 4
Gas
Inlet
Installation
CONNECT ELECTRICAL
• Plug power cord into properly grounded
receptacle.
• Verify that power is connected by opening
the oven door or press the button on the left
side of the control panel to illuminate the accent
lighting.
STEP 5
ROLL RANGE INTO POSITION
WARNING
The Anti-Tip Bracket must be properly installed
to prevent tipping of the range. Failure to do so
can cause serious damage or injury.
• Check to be sure the appliance runners are
beneath the wheels.
• The range is shipped with the wheels in the down
position. Carefully roll the range into position,
being careful not to entangle or pinch the power
cord and flexible gas tubing.
• Remove the runners beneath the range.
STEP 6
Be sure Anti-Tip
Bracket is engaged
with the brace
on the range.
14