GE ZV54ISHSS - Manual (Page 18)

18
49-80209-5
Installation Instructions
67(3
INSTALL FILTERS
• Insert the filter into the upper opening and drop
into the trays.
• To remove the filters, grasp the knobs and push
the filter up and lift out.
67(3 INSTALL RODS
• Use a flat blade screwdriver to install stand-offs
into the bottom of the hood.
• Align implement rod to stand-offs with the screw
hole towards the inside of the hood. Secure the rod
to the stand-offs with the supplied Allen wrench.
• Follow the same procedure on the opposite side.
• Place filter drip trays into the rear of the hood.
Screw
Stand-offs
Into Hood
Use Allen
Wrench to
Secure Rod
to Stand-offs
67(3 6/,'('8&7&29(5'2:1
SKIP THIS STEP IF USING THE SUPPLIED DUCT
COVER
• Hold the duct cover in place and remove the
temporary stop screw. Return the screw to the
storage location for future use.
• Slide the lower duct cover down onto the hood.
Remove
Stop
Screw
Stop Screw
Storage Location
Slide
Duct
Cover
Down