GE ZV54ISHSS - Manual (Page 19)

49-80209-5
19
67(3
INSTALLATION CHECKLIST
Check Blower Safety Screw
Ensure that blower safety screw is securely tight-
ened. See page 16, Step 9. If screw is missing, order
replacement parts bag.
Check Operating Sound and Proper Air-Flow
Turn blower to each speed setting and listen for
rattles and vibration. You should notice an audible
difference at each speed setting.
Check for foreign material in transition.
Check that blower screen is not damaged or pushed
into the blower impeller.
The damper should move freely. Listen for opening
and closing while turning the unit on and off.
Check that the damper is not damaged, does not
vibrate and that damper bumper pads are in place.
Order a damper replacement assembly if needed.
Check that ductwork is 10” round. If duct type is not
rigid and less than 10” round, inform the consumer
that performance will be reduced.
Check Lighting Function
Check that power cable is plugged into the junction
box on top of the hood.
Turn halogen lamps to each setting. Note change in
brightness at different settings.
Check that each lamp bezel is secure. Turn to the
right to tighten. Order replacement lamp bezel and
socket assemblies if needed.
Check appearance and installation
Use a spirit level to check that the hood is level.
Review installation instructions to determine source
of problem.
Top covers (if used) should lay flat in the recess on
top of the hood. Make sure side tabs are engaged in
slots and the cover is secured with two screws.
Clean the hood surfaces and all filters. See the
Owner’s Manual for cleaning instructions. They
should be free of construction debris such as
sawdust.
67(3 INSTALL SUPPLIED DUCT
COVER AND TOP COVER
67(3 FINALIZE INSTALLATION
• Check all lamps to assure tightness in sockets.
• Turn power on at the circuit breaker.
• Refer to the Owner’s Manual for operating and
cleaning instructions.
• Engage tabs into slots on each side at the top of
the hood. The covers should lay flat in the impres-
sion on top of the hood.
Installation Instructions
• Install 2 Screws C to secure the cover to the hood
at the front and back.
• Install the supplied 2-piece duct cover over the
support frame (if using supplied frame). Snap ends
together.
• Secure duct covers to support frame with 2
Screws D.
• For a more finished appearance, a top cover is
supplied and should be installed whenever the top
of the hood is visible.
Screws D
Tabs
Tape
Screws C
Top Cove
Install Screws
Front and Back
Install Duct
Cover Screw
on Each Side
TIP: Place pieces
of tape over ends
of the cover to
prevent scratch-
ing the duct
cover. Remove
tape before
installing screws.