GE 45613 GE Z-Wave 3-Way Dimmer Kit with Terminals - Manual (Page 9)

Please consult an electrician if you have trouble identifying the
type of wiring circuit you wish to convert or if you do not feel
confident in your ability to convert the circuit to Z-Wave control.
INSTALLATION
This dimmer switch may be used in new installations or
to replace an existing wall switch. It may be used by itself
for 2-way control (one switch & one load), with one 45610
Auxiliary Switch* for 3-way control (two switches & one load)
or with two 45610 Auxiliary switches for 4-way control (three
switches & one load). When used by itself for 2-way control,
please make sure that the screw terminal for the traveler wire
is insulated (Do Not Remove the tape over the terminal if you
are not using the traveler connection).
Single Switch Wiring Schematic
White (Neutral)
Z-
Wave
45610
Z-
Wave
45612
Black (Line / Hot)
Black
(Load)
Traveler - Colored (Not Green)
Green (Ground)
White (Neutral)
Z-
Wave
45612
Black (Line / Hot)
Black
(Load)
Green (Ground)