Back and bottom panel hardware and connectors, Faceplate leds – Ag Leader Base Station Hardware Manual User Manual
Page 19

Hardware Installation Manual
17
Back and Bottom Panel Hardware and Connectors
Back and Bottom Panel Hardware and Connectors
The rear and bottom panel hardware is shown in Figure 2-3.
Figure 2-3
A5 Steer Base Station Bottom
Faceplate LEDs
The faceplate of the Base Station contains LEDs that indicate system status. Table 2-2 provides details on the LEDs.
3.
Female Quick-Release Coupler (To be attached to the Base Station)
311-0005-01
4.
Male Quick-Release Coupler (To be attached to the Tripod mount)
311-0003-01
5.
Mobile Base Station (Base station has the following ports and parts):
•
Service Port Plug-in (Located on the back of the Base Station labeled SVC)
•
Radio Modem Antenna Port (Located on the back of the Base Station labeled DLINK)
•
Power Cable Plug-in (Located on the bottom of the Base Station)
•
Flexible Radio Modem Antenna (500-0090-01) (Attached to DLINK port
200-0196-04
6.
12-Volt Battery Power Supply Cable (A 12-volt marine-type, deep-cycle battery must be
supplied by the operator)
201-0173-01
Part
Description
Part Number
Threaded Tripod Mount
Power Connector
Service Port (not used)
D-Link Port