Ag Leader GPS 1100 Operators Manual - Manual (Page 15)

3000021 15
Configuration
Setup
Refer to the General Instructions section, Using GPS1000/GPS1000+/GPS1100
Utility Version 1.1; install the GPS1000/GPS1000+/GPS1100 Utility on your
personal computer.
Step-by-Step
Procedure 1. Double click on the GPS1000/GPS1000+/GPS1100 Utility icon.
2.
Click "Connect" button
3.
Select appropriate Com Port.
4.
Verify a Baud Rate of 4800 and click the "O.K." button.
5.
Select the appropriate value under Rate column as shown below.
RATE MESSAGE NAME
1 $GPGGA
OFF $GPGLL
1 $GPGSA
OFF $GPGSV
1 $GPRMC
OFF $GPVTG
OFF $GPZDA
6. Baud rate setting is dependent on the firmware version used on the processor.
Set the required Baud Rate.
Firmware Baud Rate
5.3P 9600
5.3R 4800
6.32F 4800
7. Click "Send Configuration" button.
8.
A new screen for Serial Data should now appear.
9.
Verify the serial data strings appear beginning with:
$GPGSA……………
$GPRMC……………
$GPGGA……………
10.
If the serial data strings are incorrect repeat Steps 5 through 8.
11. Configuration is now complete. Click "Exit" button.