Ag Leader EZ-Guide 500 Auxiliary Cable Installation - Manual (Page 4)

2202 South Riverside Drive, P.O. Box 2348, Ames, IA 50010
Phone: 515-232-5363 Fax: 232-3595 Internet: http://www.agleader.com
Part No. 2005948 Rev A
4 of 4
Setting up your EZ-Guide 500 system to output NMEA messages to an external device.
1. From the Run screen, select the “Wrench” button and press OK.
2. Select “System” and press OK.
3. Select “GPS” and press OK.
4. Select “NMEA Output” and press OK.
5. Select “NMEA output port” and press OK.
6. Select “AUX” and press OK.
7. Set port parameters as required by your connected external device and select “Continue”
8. Turn on the required NMEA strings and select “Continue”
9. Select the required number of decimal places and press OK.
10. Press F3 (lower left button) to return to the “Run” Screen.
11. Wait for a valid GPS signal and verify your external device is receiving NMEA messages.